threeeye
bc1d038eac
Squashed backup commit (no shallow-clone history issues) of xiaomi-mt6833-dev/kernel_xiaomi_mt6833 (lineage-23.2 branch, upstream commit 9eece662e) plus all fixes applied to get everpal_defconfig building clean against a modern (GCC 15.2.0) toolchain -- see the previous commit message on the lineage-23.2 branch (also in this repo history is not available here since this is a squashed snapshot; full incremental history lives in the local DL380 checkout and the upstream GitHub remote). Upstream: https://github.com/xiaomi-mt6833-dev/kernel_xiaomi_mt6833 (lineage-23.2)
35 lines
1.3 KiB
Plaintext
35 lines
1.3 KiB
Plaintext
* AT91 SAMA5D2 Analog to Digital Converter (ADC)
|
|
|
|
Required properties:
|
|
- compatible: Should be "atmel,sama5d2-adc".
|
|
- reg: Should contain ADC registers location and length.
|
|
- interrupts: Should contain the IRQ line for the ADC.
|
|
- clocks: phandle to device clock.
|
|
- clock-names: Must be "adc_clk".
|
|
- vref-supply: Supply used as reference for conversions.
|
|
- vddana-supply: Supply for the adc device.
|
|
- atmel,min-sample-rate-hz: Minimum sampling rate, it depends on SoC.
|
|
- atmel,max-sample-rate-hz: Maximum sampling rate, it depends on SoC.
|
|
- atmel,startup-time-ms: Startup time expressed in ms, it depends on SoC.
|
|
- atmel,trigger-edge-type: One of possible edge types for the ADTRG hardware
|
|
trigger pin. When the specific edge type is detected, the conversion will
|
|
start. Possible values are rising, falling, or both.
|
|
This property uses the IRQ edge types values: IRQ_TYPE_EDGE_RISING ,
|
|
IRQ_TYPE_EDGE_FALLING or IRQ_TYPE_EDGE_BOTH
|
|
|
|
Example:
|
|
|
|
adc: adc@fc030000 {
|
|
compatible = "atmel,sama5d2-adc";
|
|
reg = <0xfc030000 0x100>;
|
|
interrupts = <40 IRQ_TYPE_LEVEL_HIGH 7>;
|
|
clocks = <&adc_clk>;
|
|
clock-names = "adc_clk";
|
|
atmel,min-sample-rate-hz = <200000>;
|
|
atmel,max-sample-rate-hz = <20000000>;
|
|
atmel,startup-time-ms = <4>;
|
|
vddana-supply = <&vdd_3v3_lp_reg>;
|
|
vref-supply = <&vdd_3v3_lp_reg>;
|
|
atmel,trigger-edge-type = <IRQ_TYPE_EDGE_BOTH>;
|
|
}
|