threeeye
bc1d038eac
Squashed backup commit (no shallow-clone history issues) of xiaomi-mt6833-dev/kernel_xiaomi_mt6833 (lineage-23.2 branch, upstream commit 9eece662e) plus all fixes applied to get everpal_defconfig building clean against a modern (GCC 15.2.0) toolchain -- see the previous commit message on the lineage-23.2 branch (also in this repo history is not available here since this is a squashed snapshot; full incremental history lives in the local DL380 checkout and the upstream GitHub remote). Upstream: https://github.com/xiaomi-mt6833-dev/kernel_xiaomi_mt6833 (lineage-23.2)
38 lines
1.3 KiB
Plaintext
38 lines
1.3 KiB
Plaintext
* ST_LSM6DSx driver for STM 6-axis (acc + gyro) imu Mems sensors
|
|
|
|
Required properties:
|
|
- compatible: must be one of:
|
|
"st,lsm6ds3"
|
|
"st,lsm6ds3h"
|
|
"st,lsm6dsl"
|
|
"st,lsm6dsm"
|
|
- reg: i2c address of the sensor / spi cs line
|
|
|
|
Optional properties:
|
|
- st,drdy-int-pin: the pin on the package that will be used to signal
|
|
"data ready" (valid values: 1 or 2).
|
|
- drive-open-drain: the interrupt/data ready line will be configured
|
|
as open drain, which is useful if several sensors share the same
|
|
interrupt line. This is a boolean property.
|
|
(This binding is taken from pinctrl/pinctrl-bindings.txt)
|
|
If the requested interrupt is configured as IRQ_TYPE_LEVEL_HIGH or
|
|
IRQ_TYPE_EDGE_RISING a pull-down resistor is needed to drive the line
|
|
when it is not active, whereas a pull-up one is needed when interrupt
|
|
line is configured as IRQ_TYPE_LEVEL_LOW or IRQ_TYPE_EDGE_FALLING.
|
|
- interrupt-parent: should be the phandle for the interrupt controller
|
|
- interrupts: interrupt mapping for IRQ. It should be configured with
|
|
flags IRQ_TYPE_LEVEL_HIGH, IRQ_TYPE_EDGE_RISING, IRQ_TYPE_LEVEL_LOW or
|
|
IRQ_TYPE_EDGE_FALLING.
|
|
|
|
Refer to interrupt-controller/interrupts.txt for generic interrupt
|
|
client node bindings.
|
|
|
|
Example:
|
|
|
|
lsm6dsm@6b {
|
|
compatible = "st,lsm6dsm";
|
|
reg = <0x6b>;
|
|
interrupt-parent = <&gpio0>;
|
|
interrupts = <0 IRQ_TYPE_EDGE_RISING>;
|
|
};
|