threeeye
bc1d038eac
Squashed backup commit (no shallow-clone history issues) of xiaomi-mt6833-dev/kernel_xiaomi_mt6833 (lineage-23.2 branch, upstream commit 9eece662e) plus all fixes applied to get everpal_defconfig building clean against a modern (GCC 15.2.0) toolchain -- see the previous commit message on the lineage-23.2 branch (also in this repo history is not available here since this is a squashed snapshot; full incremental history lives in the local DL380 checkout and the upstream GitHub remote). Upstream: https://github.com/xiaomi-mt6833-dev/kernel_xiaomi_mt6833 (lineage-23.2)
39 lines
1.1 KiB
Plaintext
39 lines
1.1 KiB
Plaintext
Bindings for the National Instruments 169445 GPIO NAND controller
|
|
|
|
The 169445 GPIO NAND controller has two memory mapped GPIO registers, one
|
|
for input (the ready signal) and one for output (control signals). It is
|
|
intended to be used with the GPIO NAND driver.
|
|
|
|
Required properties:
|
|
- compatible: should be "ni,169445-nand-gpio"
|
|
- reg-names: must contain
|
|
"dat" - data register
|
|
- reg: address + size pairs describing the GPIO register sets;
|
|
order must correspond with the order of entries in reg-names
|
|
- #gpio-cells: must be set to 2. The first cell is the pin number and
|
|
the second cell is used to specify the gpio polarity:
|
|
0 = active high
|
|
1 = active low
|
|
- gpio-controller: Marks the device node as a gpio controller.
|
|
|
|
Optional properties:
|
|
- no-output: disables driving output on the pins
|
|
|
|
Examples:
|
|
gpio1: nand-gpio-out@1f300010 {
|
|
compatible = "ni,169445-nand-gpio";
|
|
reg = <0x1f300010 0x4>;
|
|
reg-names = "dat";
|
|
gpio-controller;
|
|
#gpio-cells = <2>;
|
|
};
|
|
|
|
gpio2: nand-gpio-in@1f300014 {
|
|
compatible = "ni,169445-nand-gpio";
|
|
reg = <0x1f300014 0x4>;
|
|
reg-names = "dat";
|
|
gpio-controller;
|
|
#gpio-cells = <2>;
|
|
no-output;
|
|
};
|